ECM
Turns ECM mode (error correction) on
or off. ECM mode is helpful in
overcoming noisy telephone line
conditions, but does require the remote
machine to support the same
communication standard.
The user parameters are accessed in sequence. If you only
need to adjust one parameter, enter the user parameter setup
as described below and answer
you reach the required setting.
To exit from the user parameters list without moving
through all the rest, press
To enter the User Parameter setup:
1. Press
.
[FUNCTION] [4] [7]
PARAMETER?
Y/N
2. Press
to move to the first parameter.
[YES]
50
to each prompt until
[NO]
again.
[FUNCTION]
Contrast
CONTRAST?
1. To adjust contrast, press
To move on to the next parameter, press
BRIGHT:NORMAL */Y
2. Press
until the required setting is displayed, then
[*]
press
.
[YES]
3. To return to standby, press
Y/N
.
[YES]
[NO]
.
[FUNCTION]
.