Pc Software Settings; Pc Interface Operation; Sending A Fax; Receiving A Fax - Oki OKIFAX 740 User Manual

PC Software Settings

Your PC fax program will normally provide several
communication settings which need to be adjusted to suit
the external fax modem, in this case your OKIFAX 740.
Appropriate settings are as follows:
Modem type:
Modem initialisation:
Pulse/Tone dialling:
Detect dial/busy tones: On.
Use ECM for Tx/Rx:
Max. baud rate:
Min. baud rate:

PC Interface Operation

In order to use this facility you must first set the PC Interface
function to ON. If you wish to discontinue using this
facility, you must set the PC Interface function to OFF
(see User Parameters).
Generic Class 1 (software flow
control).
Leave at default setting.
Set to suit your local telephone
network (the same setting as used
in your OKIFAX 740).
Usually on.
9600 bit/s.
2400 bit/s.

Sending a Fax

When the PC interface function has been turned on, your
OKIFAX 740 will operate as an external fax modem.
Outgoing fax documents may be prepared using a variety
of text editors and other programs, or with the editor buit
into your PC fax program. The operation manual supplied
with your PC fax program will guide you through the
normal operations of sending and receiving fax messages.

Receiving a Fax

To receive messages automatically when your PC fax
program is running, set the number of rings in the program
to a value from 1 to 9, as required. If this setting is set to 0,
your OKIFAX 740 will not receive messages automatically.
When set to a value greater than 9, your OKIFAX 740 will
receive incoming fax messages without using the host PC.
Note: When an incoming or outgoing fax message is in
progress via the PC Interface, all buttons except
are disabled. To halt the progress of a fax transaction
in thos mode, press
select the STOP function within your PC fax
program.
on the fax machine, or
[STOP]
[STOP]
63