Table of Contents
Advertisement
Contents
Connections
Connecting speakers
NOTE
0 Disconnect this unit's power plug from the power outlet before connecting the
speakers.
0 Connect so that the speaker cable core wires do not protrude from the speaker
terminal. The protection circuit may be activated if the core wires touch the rear
panel or if the + and - sides touch each other. "Protection circuit" (v p. 99)
0 Never touch the speaker terminals while the power cord is connected. Doing so
could result in electric shock.
0 Use speakers with impedances within the ranges shown below to suit how they
are used.
Speaker terminals
No. of connected
used on this unit
SPEAKER
SYSTEMS A
(Standard
connection)
SPEAKER
SYSTEMS B
SPEAKER SYSTEMS
A and B
SPEAKER SYSTEMS
A and B
(Bi-wiring
connection)
Front panel
Rear panel
Playback
Speaker
speakers
Impedance
2 (one set)
4 – 16 Ω/ohms
2 (one set)
4 – 16 Ω/ohms
4 (two sets)
8 – 16 Ω/ohms
2 (one set)
4 – 16 Ω/ohms
Remote control
unit
Settings
Connecting the speaker cables
Carefully check the left (L) and right (R) channels and + (red) and – (black)
polarities on the speakers being connected to this unit, and be sure to
connect the channels and polarities correctly.
1
Peel off about 3/8 inch (10 mm) of sheathing from the tip of
the speaker cable, then either twist the core wire tightly or
terminate it.
2
Turn the speaker terminal counterclockwise to loosen it.
3
Insert the speaker cable's core wire to all the way into
the speaker terminal.
4
Turn the speaker terminal clockwise to tighten it.
19
Index
Tips
Appendix
Advertisement
Table of Contents
