Revision History - Western Digital Ultrastar Data102 Installation Manual

Installation Guide

Revision History

Date
November 2017
November 2017
December 2017
January 2018
January 2018
January 2018
April 2018
June 2018
December 2018
March 2019
May 2019
July 2019
Revision
1.0 Initial release
1.1
• The crossbar on the CMA was changed. See the installation
instructions for details.
• Changed required rack depth, see
5).
• Changed typical power consumption, see
Consumption (page
1.2
• Added active cable support
• Added a note regarding single IOMs in SATA TLAs. See
Data102 Description (page 2)
• Updated the Non-Op altitude specification. See
Altitude (page
• Correct the packaging images to show the two CMA boxes that
come in the accessory tray. See
1.2.1 Updated the product name
1.2.2 Added an image for cage nut positioning in the installation procedure.
1.3
• Updated information on the 2.5" drive carrier option. (topic
removed)
• Added torque requirements for all screws used in the enclosure.
• Updated the IOM replacement section to account for the possibility
of a firmware mismatch. (topic removed)
• Updated the drive assembly installation instructions to clarify the
orientation of the drive assemblies. See
1.4
• Updated Compatible Drives List. See
(page 9).
• Updated the Rack Requirements. See
Requirements (page
1.5
• Updated the Compatible Drives List. See
(page 9)
1.6
• Updated Compatible Drives List. See
(page 9)
1.7 Updated Installation (page 35)
1.8 Updated Installation (page 35)
1.9
Comment
Required Rack Depth (page
4).
4).
Packaging Layout (page
List of Compatible Drives
Ultrastar Data102 Rack
6).
List of Compatible Drives
Revision History
Typical Power
Ultrastar
Non-Operational
29).
Installation (page 35).
List of Compatible Drives
iii