Revision History - Western Digital Ultrastar Data60 Installation Manual

Installation Guide

Revision History

Date
November 2017 Revision 1.0
November 2017 Revision 1.1
December 2017 Revision 1.2
January 2018
January 2018
January 2018
April 2018
June 2018
December 2018 Revision 1.6
Revision
Initial Release
• The crossbar on the CMA was changed. See the installation
instructions for details.
• Changed required rack depth, see
5).
• Changed typical power consumption, see
Consumption (page
• Added active cable support
• Added a note regarding single IOMs in SATA TLAs. See
Ultrastar Data60 Description (page 2)
• Updated the Non-Op altitude specification. See
Operational Altitude (page
• Correct the packaging images to show the two CMA boxes
that come in the accessory tray. See
28).
Revision 1.2.1 Updated the product name
Revision 1.2.2 Added an image for cage nut positioning in the installation
procedure.
Revision 1.3
• Updated information on the 2.5" drive carrier option. (topic
removed)
• Added torque requirements for all screws used in the
enclosure.
• Updated the IOM replacement section to account for the
possibility of a firmware mismatch. (topic removed)
• Updated the drive assembly installation instructions to clarify
the orientation of the drive assemblies. See
Installation Procedure (page
Revision 1.4
• Updated Compatible Drives List. See
(page
• Updated the Rack Requirements. See
Requirements (page
Revision 1.5
• Updated the Compatible Drives List. See
Drives (page 9)
• Updated Compatible Drives List. See
(page 9)
Comment
4).
4).
35).
9).
6).
Revision History
Required Rack Depth (page
Typical Power
Non-
Packaging Layout (page
Ultrastar Data60
List of Compatible Drives
Ultrastar Data60 Rack
List of Compatible
List of Compatible Drives
iii