Advertisement
2.0 Overview
Alarm Input: Join the grounding ends of the sensor and the camera and then connect
the signal cable of the sensor to the alarm input port of the camera.
Alarm Output: Loosen the screws in the alarm output port. Then insert the signal wires
of the alarm output devices into the port of COM and OPEN separately. Finally tighten
the screws. Some of the external alarm output devices need the power supply.
7
1.
2. Audio Input (MIC)
3. Audio Output (HP)
4. CVBS Video Output
5. Alarm Input/Output
6. Power Connector (Can be
7.
8. A - Zoom +, B- Focus
9. A - Zoom-, Zoomw
10. DC IN & CVBS Interface
11. Reset
Security Cap
DC12V
Ethernet Connector (It is
recommended to install the
security cap for outdoor
installation)
powered by DC12V/PoE power
supply. If the PoE switch is used
to power the camera, DC12V
power supply is not required.)
Micro SD Card Slot
Advertisement
