Advertisement
2.0 Overview
1.
2. Power Connector
3. Mounting Base
Note: Micro SD card slot and reset are optional. If no such interfaces, please
skip these instructions.
•
•
Connecting Network Cable
1.
2. Run the network cable (without RJ 45 connector) through both elements. Then crimp
3. Connect the cable to the hermetic connector. Then tighten the nut and the main
6
Network Connector
DC12V
It is recommended to install the security cap for outdoor installation.
If the PoE switch is used to power the camera that supports PoE power supply, DC12V
power supply is not required.
Loosen the nut from the main element.
the cable with RJ 45 connector.
cover.
4. Fixed Screw
5. Micro SD Card Slot*
6. Reset*
Security Cap
Advertisement
