Table of Contents
Advertisement
2.0 Overview
Type A : Motorised Zoom Camera
Type B : Manual Zoom Camera
•
•
Alarm Input: Join the grounding ends of the sensor and the camera and then connect
the signal cable of the sensor to the alarm input port of the camera.
Alarm Output: Loosen the screws in the alarm output port. Then insert the signal wires
of the alarm output devices into the port of COM and OPEN separately. Finally tighten
the screws. Some of the external alarm output devices need the power supply.
7
Security Cap
If the PoE switch is used to power the camera, DC12V power supply is not required.
It is recommended to install the security cap for outdoor installation.
1.
Ethernet Connector
2. Audio Input (MIC)
3. Audio Output (HP)
4. CVBS Video Output
5. Alarm Input/Output
6. DC12V Power Connector
7.
A: Zoom- (only available for type A),
B: Focus
8. A : Zoom+ (only available for type A),
B: Zoom
9. Micro SD Card Slot
10. Reset
11. DC in & CVBS Interface
DC12V
Advertisement
Table of Contents
