Setting up a wired network connection
Use a network cable to connect your SendPro C Auto to the Pitney Bowes Data Center.
Step 1: Plug in your network cable
Plug one end of your network cable to your device and the other end to an internet jack on the wall or a
router.
Step 2: Choose the connection type
Select one of the two connection types supported for this device:
DHCP
l
Static IP
l
DHCP is the most common connection type. Choose DHCP if you are unsure which connection
protocol to use or contact your IT department for advice.
DHCP
1. Tap Settings.
2. Tap Wired.
Pitney Bowes
Operator Guide
April 2022
Connectivity information
50