Assembly Instruction - Master X-24 User Manual

ASSEMBLY INSTRUCTION:

1.PREPARATION:
A. Before assembling make sure that you will have enough space around the item.
B. Use the present tooling for assembling.
C. Before assembling please check whether all needed parts are available (at the
above of this instruction sheet you will find an explosion drawing with all single
parts (marked with numbers) which this item consists of.
2.ASSEMBLY INSTRUCTION:
:
FIG.1
FIG.2
28
FIG.1:
Lock the Front Stabilizer (pt.9) to the
Main Frame (pt.10) with two sets of
Ø8 Flat Washer (pt.6), M8 Domed
Nut (pt.7) and M8*52 Carriage Bolt
(pt.3).
Lock the Rear Stabilizer (pt.4) to the
Main Frame (pt.10) with two sets of
Ø8 Flat Washer (pt.6), M8 Domed
Nut (pt.7) and M8*52 Carriage Bolt
(pt.3).
FIG.2:
Insert the Vertical Seat Post (pt.16) into
the seat post housing on the Main
Frame. You will have to slacken the
Knob (pt.2) and pull the knob back.
Then select the desired height. Release
the knob and retighten the knob.
The Seat Post (pt.17) is fixed on the
Vertical Seat Post (pt.16) with the Knob
(pt.11) and the Flat Washer (pt.12).
Finally,the Seat (pt.18) is fixed on the
Seat Post (pt.17) with the nuts of the
seat.
EN