Table of Contents
Advertisement
Installing Multiplexers
Step
Procedure (Continued)
3
Set the Secondary Reference and press
Configure the following options:
• Bits A
DS1 speed (default) or E1 speed
• Bits B
DS1 speed (default) or E1 speed
• Internal
• Transport
• Service #1 ~ 28
4
Set the Timing Reference Switching
revert to the primary clock when it is valid.
Configure the following options:
• Revertive (default)
• Non-revertive
5
To manually force the clock synchronization mode, set Force to the desired mode.
Configure the following options:
• Normal (default)
• Primary
• Secondary
• Internal
• Hold-over
6
Return to the Config menu by pressing
7
Proceed to
"Configuring DS1 Services through the Config Menu" on page
? ? ? ?
Installer Signature
A service or transport must be configured as In-Service (IS) prior to being selected as the
synchronization source.
54
TAB
to select speed.for synchronization.
.
Setting the timing reference to Revertive causes the clock to
ESC
.
January 12, 2001
LTPH-SM-1014-03, Issue 3
Installer Check ü ü ü ü
55.
Date
HMS-358 List 1 and List 2
H
H
H
H
H
Advertisement
Table of Contents
