Table of Contents
Advertisement
LTPH-SM-1014-03, Issue 3
To fiber
network
Figure 11. Routing OC-3 Fiber-Optic Cables Through the Lower Access Hole (Left-Hand Side, Front View)
Step
Procedure (Continued)
The steps the follow
instructions that terminate at the multiplexer. This procedure requires a review of the
HXU-369 multiplexer installation procedure. See
on page 59
10
Route the network OC-3 fiber-optic cable through the access hole located on the lower, left-hand side
of the chassis and bring the cable to the front of the chassis.
11
Plug your ESD strap into the ESD input on the front of the chassis.
12
Align the edges of the HXU-369 with the slot guides in the multiplexer tray.
13
Grasping the card eject tabs, gently push the card halfway into the bay.
14
Remove the protective caps from the OC-3 fiber-optic cables.
15
Insert the fiber-optic-cable connectors into the transmit (TX) and receive (RX) transceiver
receptacles on the piggybacked card.
Route the cables through the inverted T slots in the HXU-369 front panel (see
T slots provide a method of maintaining the correct cable bend ratio.
16
Grasping the card eject tabs, gently push the card the remainder of the way into the bay.
17
Proceed to
"Wiring the Common Access Panel" on page
? ? ? ?
Installer Signature
HMS-358 List 1 and List 2
(Step 10
through
for more information.
18.
January 12, 2001
Transceiver
Tab
HXU-369
Fiber cable
Step
16) provide OC-3 fiber-optic cabling
"Installing the HXU-369 Multiplexer Card"
Figure
11). The inverted
Cabling the Chassis
Installer Check ü ü ü ü
H
H
H
H
H
H
H
H
Date
17
Advertisement
Table of Contents
