Table of Contents
Advertisement
Installing a Management Unit (HMU)
Setting the Local IP Address (Option A)
Step
Procedure
1
From the Shelf Options menu, press
2
At the prompt, enter the local IP address using the XXX.XXX.XXX.YYY format, where XXX and YYY
are decimal numbers from 0 through 255.
Do not select your own address. Your administrator should notify you of the unique address that has
been assigned to the network. For additional help on IP addressing, see
page
82.
3
Press
ENTER
.
X
4
Press
to exit the screen.
5
Press
Y
to confirm, save the setting, and reset the HMU. The program returns to the Network Status
menu (if in a multishelf configuration) or Shelf Status menu (if in a single shelf).
6
For HXU-357 multiplexers, proceed to
otherwise, proceed to
? ? ? ?
Installer Signature
Setting the Ethernet Connection (Option G)
Step
Procedure
1
From the Shelf Options menu, press
1
2
Press
and then press
For a single system installation that does not require a hubbed network connection, verify
that the special 10BASE-T cable that comes with the module is connected from the module
to the 10BASE-T (J34) connection on the back of the shelf.
If a hub is used, the 10BASE-T module can be routed directly to the hub using a Category-5
shielded connection.
3
Press
X
to exit the screen.
Y
4
Press
to confirm, save the setting, and reset the HMU. The program returns to the Network Status
menu (if in a multishelf configuration) or Shelf Status menu (if in a single shelf).
5
Proceed to
"Installing Multiplexers" on page
? ? ? ?
Installer Signature
36
A
ENTER
, then press
"Setting the Ethernet Connection (Option G)"
"Installing Multiplexers" on page
G
and then press
ENTER
to select 10BASE-T.
37.
January 12, 2001
to select Local IP Address for the HMU.
"Network Specifications" on
37.
ENTER
to select Change Ethernet Connection.
LTPH-SM-1014-03, Issue 3
Installer Check ü ü ü ü
H
H
H
H
H
H
below;
Date
Installer Check ü ü ü ü
H
H
H
H
H
Date
HMS-358 List 1 and List 2
Advertisement
Table of Contents
