Table of Contents
Advertisement
Related Documentation
R
D
ELATED
OCUMENTATION
Catalog/Document Number
400-100-100-xx
150-357-200-xx
150-358-100-xx
150-359-100-xx
150-369-100-xx
150-357-100-xx
100-319-200-xx
350-319-200-xx
350-319-201-xx
150-319-107-xx
For information about line units, doublers, remotes and management units, refer to the
appropriate practice for the product model number.
S
W
AFETY
ARNINGS AND
The DC power supply feeds of the enclosure must be connected to either (1) -48 VDC SELV
sources or (2) -48 VDC sources which are electrically isolated from the AC sector and reliably
connected to earth. The source's fault current capacity shall be lower than 50 A, or an
appropriate overcurrent protection, rated 5 A, must be provided on each -48 Vdc conductor. The
overcurrent protection can also be used as a cut-off switch if another disconnect device is not
installed.
This equipment may be provided with a module that incorporates laser source(s). Refer to the
module's documentation for detailed safety information.
The telemetry I/O must be connected to either a SELV source or a ELV source that is electrically
isolated from the AC sector and reliably connected to earth.
The metallic telecommunication interface should not leave the building premises unless
connected to telecommunication devices providing primary and secondary protection.
iv
Title
TL1 Command Set Reference
HXU-357 List 1 Multiplexer Unit
HXU-358 List 1 Multiplexer Unit
HXU-359 List 1 Multiplexer Unit
HXU-369 List 1 Multiplexer Unit
HFA-357 List 1 Fan Assembly Unit
HTC-319 List 1 Test Card
HCC-319 List 1 Cut-through Card
HCC-319 List 2 Cut-through Card
HMU-319 List 7 and 7A
N
OTICES
January 12, 2001
LTPH-SM-1014-03, Issue 3
HMS-358 List 1 and List 2
Advertisement
Table of Contents
