Table of Contents
Advertisement
Cabling the Chassis
Step
Procedure
1
Attach the drain wire of the female amphenol cable connector to the screw hole of the male amphenol backplane connector
and tighten the drain wire to the backplane with one 4-40 x
2
Connect the female amphenol cable connector to the male amphenol backplane connector.
3
Tighten the retaining screw (the screw encased within the cable) into the screw hole of the male amphenol backplane
connector.
4
Lace a cable tie through the lance bridge on the rear cover, wrap the tie around the female amphenol cable, thread the tip
of the tie through the eye of the tie, and then pull the tip of the tie until the cable tie is completely snug.
C
C
ABLE
ONNECTOR
Following are a list of pinouts for 16/16 and 25/7 for 50- and 200-foot cable connectors (see
Connector Pinout and Color Code (16/16 Cable)," on page 11
Code (25/7 Cable)," on page
Figure 5. 50-foot (16/16 or 25/7) or 200-foot (16/16 or 25/7) Cable Connectors
10
P
INOUTS
11).
Drain wire
January 12, 2001
1
/
screw.
2
and
Table 4, "Cable Connector Pinout and Color
16/16
or
25/7
32
1
64
33
LTPH-SM-1014-03, Issue 3
Table 3, "Cable
HMS-358 List 1 and List 2
Advertisement
Table of Contents
