Table of Contents
Advertisement
Installing a Management Unit (HMU)
U
T
SING THE
ERMINAL
You can use the Terminal Access Option (TAO) interface to access and manage all the components of the
HMS-358, including the line units, multiplexers, shelf, and the associated doublers and remote units.
shows the various logon procedures based on your system configuration.
For complete information on TL1, refer to TL1 Command Set Reference, catalog number
LTPH-RG-1028-06.
At the time of this writing, all versions of software respond to at least one of the following
procedures described in this guide.
At the prompt, type
, and then press
tao
Depending on your system configuration (HMU software version), one of the following options are presented:
At the
enter password
or
At the
Please Log off Tl1 session and re-type TAO to Login TAO
At the
Logged out OK
At the
prompt,
password
or
At the
Please Log on to local TL1 with proper privilege and re-type TAO
At the
Enter TID [local]
At the
Enter username
At the
prompt,
password
At the
prompt,
type
<
Multishelf configuration (see Figure 22)
Single-shelf configuration (see Figure 23)
? ? ? ?
Installer Signature
Proceed to
"Configuring the Management Unit" on page
32
A
O
CCESS
PTION
ENTER
.
prompt,
type
(default) and
public
prompt,
type
,
then
press
tao
type
(default) and press
public
prompt, type the shelf ID (if necessary) or press
prompt,
type
superuser
type
(default) and press
public#1
ENTER
(default) and press
tao
Select shelf to configure
Figure 21. Using the Terminal Access Option
January 12, 2001
ENTER
press
.
prompt,
ENTER
.
ENTER
.
ENTER
ENTER
(default) and press
.
ENTER
.
.
34.
LTPH-SM-1014-03, Issue 3
Figure 21
type
logoff;
ENTER
prompt, press
.
.
Pre-assigned IP address
No pre-assigned IP address
Date
HMS-358 List 1 and List 2
or
Advertisement
Table of Contents
