Port Information - Epson TM-H6000III Series Development Manual

Do not change the current settings of DIP-SW2-5 to DIP-SW2-8.
Make other settings in accordance with the settings described above.
4) Ethernet Port
DIP-SW1
No. Setting
1
2
3
4
5
6
7
8
It is possible to change the settings of DIP-SW1-1 and DIP-SW1-2, but it is
recommended to leave them OFF.
Set DIP-SW2-3 and DIP-SW2-4 to match the environment of use.
Do not change the current settings of DIP-SW2-5 to DIP-SW2-8.
Make other settings in accordance with the settings described above.

2.3 Port Information

1) Port information when serial port is used
The port information that can be set with the SetupPOS utility is as follows.
Baud rate [bps]
Bit length [bit]
Parity
Stop bit [bit]
Handshake
Output buffer length [byte]
Output interval time [ms]
OFF Recommended
OFF Recommended
OFF Fixed at OFF
OFF Fixed at OFF
OFF Fixed at OFF
OFF Fixed at OFF
OFF Fixed at OFF
OFF Fixed at OFF
Item
APPLICATION DEVELOPMENT GUIDE
POSPrinter (TM-H6000III)
DIP-SW2
No. Setting
1 OFF
2 OFF
3 OFF
4 OFF
5 OFF
6 OFF
7 OFF
8 ON
Setting range
4800, 9600, 19200, 38400
8
NONE, ODD, EVEN
1
DTR/DSR
32 to 1024
0 to 9999
4
Version 3.00 Feb. 2019
Settable
Fixed at OFF
Settable
Settable
Fixed at OFF
Fixed at OFF
Fixed at OFF
Fixed at ON