Specifications; Setup - Central Machinery 33497 Owner's Manual & Safety Instructions

Specifications

Note: For additional information regarding the parts listed in the following pages, refer
to the Parts List and Assembly Diagram near the end of this manual.
Setup - Before Use:
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Inspect tool before use, looking for damaged, loose, and missing parts.
If any problems are found, do not use tool until repaired.
Components of this Shop Press are heavy. You will need a helper to safely assemble this product.
Note: For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual.
Assembly
1. Using the Components and Controls section and the
Parts List and Diagram near the end of the manual,
lay out and identify all pieces before assembly.
2. Have a helper hold the Frame Posts (15)
vertically, and hold them steady until the
Spreader (16) and Base Supports (14)
are secured in place. See Figure A.
Frame Posts (15)
M10x30
Bolts (12)
Spreader (16) M10 Nuts
M10 Nuts
(13)
Figure A
3. Slide each Base Support under the Frame
Posts, and place the Spreader between them,
as shown above. Line up the bolt holes and
insert four M10x30 Bolts (12) through the
Spreader, Base Supports and Frame Posts,
then secure in place with four M10 Nuts (13).
Page 4
Maximum
Capacity
Oil Type
(13)
Base Supports (14)
For technical questions, please call 1-888-866-5797.
12 Tons
(24,000 pounds)
Hydraulic Oil
4. Determine where you want to use the Press. Check
to ensure that the Frame Posts are perpendicular
to the Base Supports, then bolt to the floor.
Refer to Mounting to the Floor on page 6.
5. Align the holes on the Upper Beam (1) with
the holes in the top of the Frame Posts and
secure in place with four M12x110 Bolts (3) and
M12 Nuts (2). Check that the assembly is square,
then finish tightening bolts. See Figure B.
M12 Nuts (2)
Frame Posts (15)
Figure B
Upper
Beam (1)
M12x110
Bolts (3)
Item 33497