Specifications; Instructions For Putting Into Use - Central Machinery 65589 Set Up And Operating Instructions Manual

SPEcIFIcATIOnS

Electrical
120 V~ / 60 Hz / 1/4 HP
Requirements
Spindle Pulley
570, 900, 1390, 2050, 3050
Speeds (RPM)
Column 2-5/16" (diameter) tube
Base Dimensions 13" L x 8" W x 1-7/8" H
Throat Depth 5" Deep
Keyed, 3-Jaw Chuck
Chuck/Capacity
1/16" - 1/2" diameter
Table Slot 2-7/8" L x 9/16" W
0-45° In 1° Increments
Table Rotation
(Right and Left)
Table Size 12" L x 11-3/4" W x 2-7/8" H
(2) 1.5V "AA" Batteries (not
Laser Batteries
included)
DO nOT STARE InTO BEAm
max. Power Output: < 1mW,
Wavelength: 640-660 nm
CLASS II LASER PRODUCT
This product complies with
21 CFR 1040.10 and 1040.11
3491 Mission Oaks Blvd.,
Camarillo, CA, USA, 93011
Manufacture Date: ___________, _______
InSTRucTIOnS FOR
PuTTIng InTO uSE
Read the EnTIRE ImPORTAnT
SAFETY InFORmATIOn
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
FROm AccIDEnTAL
OPERATIOn: Turn the Power
Switch of the tool to its "OFF"
position and unplug the tool
from its electrical outlet
before assembling or making
any adjustments to the tool.
SKU 65589
LASER LIgHT
CEN-TECH
TO PREVEnT
SERIOuS InjuRY
For technical questions, please call 1-800-444-3353.
note: For additional information regarding
parts listed, refer to Assembly Dia-
gram near end of this manual.
Assembly
1. Position Base (1) on floor, on spot
able to support weight of Drill Press.
2. Place Support Column (2) on Base
and align holes in Support Column
with holes on Base.
3. Using wrench (not included) fasten
Support Column to Base using four
Hex Head Screws (3). Tighten until
secure. See Figure A, below.
Support
Column (2)
Hex Head
Screws (3)
Figure A
4. Loosen the set screw in the Rack
Collar (7) with Hex Wrench and
remove Rack Collar from Support
Column. See Figure B, below.
Rack Collar
(7)
Support
Column (2)
Rack (5)
Figure B
5. Insert the Elevation Shaft (13) into
the Table Support (11) and slide the
Shaft through the opening as far as
possible. Then thread the Crank (10)
onto the end of the Elevation Shaft
Rack (5)
Base (1)
Hex Wrench
Page 9