Motor
16 Spindle Speeds
Spindle
Column
Base Dimensions
Throat Depth
Chuck Capacity
Table Slot
Table Rotation
Table Size
You will need the manual for the safety warnings and precautions, assembly instructions,
operating and maintenance procedures, parts list and diagram. Keep your invoice with this
manual. Write the invoice number on the inside of the front cover. Keep the manual and
invoice in a safe and dry place for future reference.
WARnIng: When using tool, basic safety precautions should always be followed to
reduce the risk of personal injury and damage to equipment.
Read all instructions before using this tool!
1.
Keep work area clean. Cluttered areas invite injuries.
2.
Observe work area conditions. Do not use machines or power tools in damp or wet
locations. Don't expose to rain. Keep work area well lighted. Do not use electrically
powered tools in the presence of flammable gases or liquids.
3.
Keep children away. Children must never be allowed in the work area. Do not let
them handle machines, tools, or extension cords.
4.
Store idle equipment. When not in use, tools must be stored in a dry location to
inhibit rust. Always lock up tools and keep out of reach of children.
5.
Do not force tool. It will do the job better and more safely at the rate for which it
was intended. Do not use inappropriate attachments in an attempt to exceed the tool
capacity.
6.
use the right tool for the job. Do not attempt to force a small tool or attachment to
SKU 43378
Specifications
120 VAC, 60 Hz, 3/4 HP, 1750 RPM; 5.8 amps
(with load)
220, 300, 430, 480, 590, 650, 720, 850, 950,
1600, 1900, 2000, 2500, 2900, and 3600 RPM
Stroke: 3-1/8 inches; Taper: MT2
2-7/8 (diameter) inches
10-1/8 x 17-1/2 inches; Slots: 5/8"
6-5/8 inches (of 13 inch swing)
7/64 to 5/8 inches; Taper: JT3
5/8 inches
360°; Tilt: 45° (left and right)
11-5/8 (diameter) inches
Save this Manual
Safety Warnings and Precautions
Page 2
36ZJ
E105017
REV 00j