Kenwood HM-582MD Instruction Manual page 74

Contents
74
Be sure to adjust the clock before setting the timer.
2 Select the input source.
1 Select the source to be played.
volume/
multi-control
2 Press the set key.
3 Select the broadcast station (only when TUNER is selected).
1 Select the preset station No.
volume/
multi-control
2 Press the set key.
6
Set the program.
1 Select "ON" or "OFF" by rotating the volume/
multi-control knob, then press the set key.
volume/
multi-control
÷ The set program contents are displayed when the
program is set to "ON".
2 Press the
/timer key to switch the power
OFF (standby).
(The /timer indicator lights in amber.)
t i m e r
Now the program timer reservation is complete.
Use the same procedure as above when you want to
reserve a program timer operation in PROG.2.
Ensure that the power is OFF.
÷ With timer recording of radio broadcasting, the audio is muted automatically at the moment the power is switched ON by
Notes Notes Notes
the timer.
÷ The reservation contents cannot be cleared. The contents are cleared only when they are changed.
÷ If the
/timer indicator blinks in amber when the power is switched OFF (Standby), the timer will not be executed.
In this case, set the clock again. %
÷ After the timer has been set and power is off (timer standby), if there is a power failure or the power cord is unplugged
from and plugged again into the power outlet, the standby/timer indicator blinks in amber. In this case, set the clock again.
TUNER
CD
MD
AUX (Analog)
DIGITAL AUX (Digital)
SOURCE
TUNER
TONE
PROG 1
TUNER P01
90.00MHZ
\
\
(
3 Select the broadcast station
(only when TUNER is selected).
volume/
multi-control
4 Select the recording unit.
(only when TUNER or AUX is selected)
volume/
multi-control
1 When ON is set
PROG.1
‰ ON
Blinks
TONE
PROG
AU TO
÷ The timer operation will not occur if the program is not set to
ON.
Remote control unit operation
Each press switch the modes as follows.
O.T.T.
PROG.1
PROG.2
PROG.1, 2
Goes off (OFF)
÷ The remote control unit can be used only to set the timer
activation ON or OFF. The time setting should be per-
formed on the main unit.
Timer operation
Select the preset sta-
tion No.
Press the set key.
ANALOG
MONO
Press the set key.
1
TIMER