Clock Adjustment - Kenwood HM-582MD Instruction Manual

Clock adjustment

This unit incorporates a clock function. Be sure to
adjust the correct time before using the timer func-
tion.
If there is a power failure or the power cord is
unplugged then plugged in again while the power
set to off (STANDBY mode) after a timer is activated,
the /timer indicator blinks in amber.
In this case, adjust the clock again.
Switching the power ON
1
Activate the clock adjustment mode.
1 Press the menu/demo key.
2 Rotate the volume/multi-control knob to select
"TIME ADJUST ?", then press the set key.
3 Select "12 HOUR" or "24 HOUR" by rotating the
volume/multi-control knob, then press the set
key.
2
Enter the hour.
1 Adjust the figure of hour by rotating the volume/
multi-control knob.
To put back
the time
volume/
multi-control
2 Press the set key.
3
Enter the minute.
1 Adjust the figure of minute by rotating the vol-
ume/multi-control knob.
To put back
the time
volume/
multi-control
2 Press the set key.
When power is OFF (standby) :
Press the 7 STOP key to display the time of the day
for 5 seconds.
2 Select "TIME ADJUST ?"
3 Select the time display mode.
÷ The time of the day is represented in 12-hour or 24-hour
1 Setting the hour
To advance
the time
÷ The time display starts to blink.
÷ Press the set key. The hour is entered and the minute display
1 Setting the minute
To advance
the time
÷ If you pressed the set key by mistake, press the menu/
÷ To adjust correct time, press the set key at the same moment
7 STOP
menu/demo
T A 00?
IME DJUST
12:00
PM
T A
IME DJUST
12:H
‰
OUR
method.
T A
IME DJUST
1:00
PM
TONE
Blinks
starts to blink.
T A
IME DJUST
1:30
PM
TONE
Blinks
demo key and restart from the beginning.
as a time announcement.
Contents
Menu mode
set
volume/
multi-control
7 STOP
Blinks
0
Blinks
0 Example for adjusting at
1:30PM
15