Panasonic PV-DV102PN Service Manual page 23

Leadless capacitor must be preheated before installation.
(130 °C ~ 150 °C, for about 2 minutes.)
Note:
A. Leadless component must not be reused after removal.
B. Excessive mechanical stress and rubbing of the component
electrode must be avoided.
2. Removing the leadless component
Grasp the leadless component body with tweezers and alternately
apply heat to both electrodes. When the solder on both electrodes
is melted, remove leadless component with a twisting motion.
Note:
A. Do not attempt to lift the component off the board until the
component is completely disconnected from the board by a
twisting action. The leadless component is attached to the PCB
with glue. So carefully twist the component when removing it so
as not to break or damage any fail under the component.
B. Take care not to break the copper foil on the printed board.
3. Installation of the leadless component
A. Presolder the contact points of the circuit board.
B. Press the part downward with tweezers and solder both
electrodes as shown below.
Fig. 9-1
Fig. 9-2
Fig. 9-3
23