Symptoms - Husqvarna AUTOMOWER 405X Operator's Manual

6.5 Symptoms

If the product does not operate as usual, follow the symptoms table below. Speak to your Husqvarna customer
service if you cannot find the cause for the fault.
Symptoms Cause
The product has diffi- The guide wire is not put straight in a line
culty docking. and correct distance from the charging sta-
tion.
The guide wire is not put in the slot in the
charging station plate.
The charging station is not on a level sur-
face.
The product operates The time or the date in the product is not
at the wrong time correct.
The start and stop times for operating are
incorrect.
The product vibrates. The cutting system is not in balance because
of damaged blades.
The cutting system is not in balance because
of too many blades in the same position.
Different thickness of blades are installed on
the product.
The product oper- The product searches for the charging sta-
ates, but the blade tion, or is moving to the starting point.
disc does not rotate.
The product operates Grass or other object causes a blockage to
for shorter periods the blade disc.
than usual between
charges.
The battery is at the end of its life cycle.
Blunt blades. More energy is necessary
when cutting the grass.
Mowing and charg- The battery is at the end of its life cycle.
ing times are shorter
than usual.
1650 - 005 - 17.03.2022
Action
Do a check of the installation of the charging
To install the charging sta-
station. Refer to
tion on page 18
Make sure that the guide wire is put straight
in a line and put in the slot in the charging
station plate. Refer to To install the guide
wire on page 18 .
Put the charging station on a level surface.
To examine where to put the charg-
Refer to
ing station on page 13 .
Set the time or date. Refer to
& date on page 28 .
Schedule settings. Refer to
Change the
Schedule on page 21 .
Examine the blades and screws and replace
Replacement of
them if necessary. Refer to
the blades on page 34 .
Do a check that only one blade is attached at
each screw.
Do a check if the blades are of different thick-
ness and replace if necessary.
Usual operation for the product. The blade
disc does not rotate when the product is
searching for the charging station.
Remove and clean the blade disc. Refer to
To clean the chassis and blade disc on page
33 .
Replace the battery. Refer to
page 35 .
Replace the blades. Refer to
the blades on page 34 .
Replace the battery. Refer to
page 35 .
Troubleshooting - 43
To set the time
Battery on
Replacement of
Battery on