Jacuzzi LX J - LX Owner's Manual page 20

LX Collection
ImporTanT: Always fill your spa through the filter bucket after
draining. Failure to do so may cause air to be trapped in either
pump, preventing the pump from circulating water. Remove the
hose and replace the filter cartridge. Note: DO NOT overtighten
filter cartridge, finger tight only!
3. Turn on power
Turn on power to spa at the home's circuit breaker to start boot
up sequence (Sec. 10.0, page 27). The heater and filter pump will
automatically activate after several seconds. If the control panel LED
flashes water temperature and "COL" or "ICE" this is normal, refer to
page 42 for additional information.
4. activate Jets pumps
Turn on jets pump(s) to ensure proper mixing when adding
start-up chemicals in step 5.
5. add start-up Chemicals
Add the spa water chemicals as recommended by your authorized
Jacuzzi dealer. See Section 13.0 "Water Quality Maintenance" (page 40)
for general guidance.
warnInG:
!
Never leave chemicals opened and accessible to anyone. Use
chemicals according to the vendors instructions. Always store
chemicals in a safe and/or locked location. Keep away from
and out of reach of children.
6. establish a stable sanitizer reading
Establish a stable sanitizer reading between 3.0-4.0 ppm chlorine or 2.0-
4.0 ppm bromine. To ensure healthy water conditions, always maintain
a constant sanitizer reading within the levels recommended by the
Association of Pool and Spa Professionals/USA printed on the inside
cover of this manual. If sanitizer levels cannot be stabilized, perform the
decontamination procedure steps 9-16 on pages 17-19.
note: The "decontamination procedure" steps 9-16 should also be used
after the spa has been "Winterized" (Section 12.9 page 39) or has been
sitting without power for an extended period.
7. set spa To Heat
To warm spa water to a comfortable temperature, follow
these steps:
• The LED display on the control panel displays the actual temperature
of the spa water. Press either the Cooler (
( ) button once to display the "set" temperature for 5 seconds. If
you want the water to heat to a different temperature, simply press
Cooler (
16
rIsK oF poIsonInG or DeaTH.
) or warmer (
) or warmer
) within 5 seconds. The set
1
2