Averaging The Remote Sensor With Thermostat Sensor - Carrier 33CS450-01 Owner's Manual

Averaging the Remote Sensor (RS Averaging the Remote Sensor (RS
the Thermostat Sensor the Thermostat Sensor
If step #37 is set to control to the remote sensor, the thermostat will
ignore the reading of its internal temperature sensor and only display
the temperature reading from the remote sensor. The degree icon on
the thermostat will blink once per second to indicate that a remote
sensor reading is being displayed.
If step #38 is set to ON (see below), the thermostat will average its
internal sensor with the wired temperature sensor connected to RS1.
I f multiple remote temperature sensors are installed on RS1, they will
automatically average together.
average of the thermostat's internal sensor and the remote (RS1)
sensor(s).
Press the MODE button. While holding
MODE
the MODE, press the PROGRAM
button to enter Setup screens.
PROGRAM
Press the MODE button repeatedly
MODE
until this setup screen appears.
Optional Remote Sensor
On
Operation:
ON = Averages thermostat
sensor with Remote
Sensor 1.
OFF = Does not average
thermostat sensor
Off
with Remote Sensor 1.
Press the PROGRAM button to leave the Setup screens. If no buttons are
pressed, the display will leave the setup screens after 30 seconds.
1 1
) with ) with
The temperature displayed will be the
Note: Press the
button momentarily
to move through the
setup screens. Press
and hold the
button to move back-
wards through the
setup screens.
38
Setup
OFF
Remote
Page 15.4
Carrier
MODE
MODE
15
Press
PROGRAM