Controlling Or Reading The Remote Temperature Sensor - Carrier 33CS450-01 Owner's Manual

Controlling or Reading the Controlling or Reading the
Remote Temperature (RS ) Remote Temperature (RS
The thermostat may be programmed to only READ the remote sensor,
or to CONTROL to the remote sensor. Refer to advanced setup step
#37, below.
Read Only Sensor (RS1): If step #37 is set to only READ to the
remote sensor, the thermostat will not use this sensor for temp-
erature control. This sensor may be viewed by entering advanced
setup (see below) and pressing and holding the MODE button to
scroll backwards one step to setup step #48 (see page 22.4).
Control Sensor (RS1): If step #37 is set to CONTROL to the remote
sensor, the thermostat will ignore the reading of its internal
temperature sensor and only display the temperature reading from
the remote sensor. The degree icon on the thermostat will blink
once per second to indicate that a remote sensor reading is being
displayed.
Press the MODE button. While holding
MODE
the MODE, press the PROGRAM
button to enter Setup screens.
PROGRAM
15
Press the MODE button repeatedly
MODE
until this setup screen appears.
YES
Optional Remote Sensor:
YES = Control to Remote
Sensor RS1.
NO = Read Only Remote
Sensor RS1.
NO
Press the PROGRAM button to leave the Setup screens. If no buttons are
pressed, the display will leave the setup screens after 30 seconds.
1 1
)
Note: Press the
button momentarily
to move through the
setup screens. Press
and hold the
button to move back-
wards through the
setup screens.
37
Setup
Remote
Page 15.3
Carrier
MODE
MODE
Press
PROGRAM