Time-Based Control Of The Programmable Output - Carrier 33CS450-01 Owner's Manual

Time-Based Control of the Time-Based Control of the
Programmable Output Programmable Output
To operate one of the MISC outputs using time-based operation, set
Advanced Setup step #30 (below) for Time
will supply 24VAC to the selected MISC terminal, which is especially
useful for devices that require a start and stop time. Refer to page
14.4 - 14.5 for more details on programming this output.
Possible TIME scenarios:
1) An exterior lighting system that needs to be energized every
day between the hours of 8pm and 1am.
2) A sprinkler system that needs to be energized every day
between the hours of 2am and 4am.
Press the MODE button. While holding
MODE
the MODE, press the PROGRAM
button to enter Setup screens.
PROGRAM
Press the MODE button repeatedly
MODE
until this setup screen appears.
I8:88
88
OFF Time = Temp =
Press the UP button to
set the programmable
output for time based
operation. The digits in the
clock area will appear.
i8:88
. This extra output
Note: Press the
button momentarily
to move through the
setup screens. Press
and hold the
button to move back-
wards through the
setup screens.
Aux
30
I8:88
Setup
Continued on
the next page
Page 14.3
Carrier
MODE
MODE
14
Press
MODE