Usage Guidelines; If You Need Assistance - InFocus LPTM425z User Manual

Usage Guidelines

Do not look directly into the projection lens when the projector
•
is turned on. The bright light may harm your eyes.
Do not block the grills on the projector. Restricting the air flow
•
can cause it to overheat and turn off. If this happens, you must
wait a minute before attempting to turn it back on.
Handle the projector as you would any product with glass
•
components. Be especially careful not to drop it.
Avoid leaving the projector in direct sunlight or extreme cold
•
for extended periods of time. If this happens, allow it to reach
room temperature before use.
This projector is not intended for use in mainframe computer
•
rooms as defined in the Standard for the Protection of Elec-
tronic Computer/Data Processing Equipment, ANSI/NFPA 75.
Transport the projector in a vendor-approved hard or soft case.
•
Part numbers for these cases are listed on page 48.

If You Need Assistance

The first place to look for help is in this manual. Be sure to check
the guidelines in "Troubleshooting" on page 40. Or, check the
Service and Support section of our website at
http://www.infocus.com/service.
If those sources don't answer your question, call your InFocus
dealer. You can also call InFocus Customer Service directly at
. Call between 6 a.m. and 6 p.m. PST, Monday
1-800-799-9911
through Friday. Service is available in North America after hours
and on weekends for a fee at
In Europe, call InFocus in The Netherlands at
between 8 a.m. and 6 p.m. Central European
(31) 35-6474010
Time.
In Asia, call
(65) 332-0659
Or, send us an e-mail at
Our World Wide Web address is
1-888-592-6800
between 9:30 a.m. and 5:30 p.m.
techsupport@infocus.com
http://www.infocus.com.
.
5