Usage Guidelines - InFocus LP400 User Manual

focus ring
elevator button
power
cord
connector

Usage Guidelines

Do not look directly into the projection lens when the projector
•
is turned on. The bright light may harm your eyes.
Do not block the grills on the projector. Restricting the air flow
•
can cause it to overheat and turn off. If this happens, you must
wait a minute before attempting to turn it back on.
Handle the projector as you would any product with glass
•
components. Be especially careful not to drop it.
Avoid leaving the projector in direct sunlight or extreme cold
•
for extended periods of time. If this happens, allow it to reach
room temperature before use.
This projector is not intended for use in mainframe computer
•
rooms as defined in the Standard for the Protection of Elec-
tronic Computer/Data Processing Equipment, ANSI/NFPA 75.
Transport the projector in a vendor-approved hard or soft case.
•
Part numbers for these cases are listed on page 40.
power switch
keypad
connector panel
speaker
F
IGURE
Side view of projector
2
3