> Lower the presser foot.
> To lower the presser foot, push the button «Start/Stop» or press the foot control.
– A red light is lit on the BSR Presser Foot.
> Move the fabric to control the speed of the machine in the BSR mode.
> To stop the BSR Mode, push the button «Start/Stop» again or release the foot control.
– The BSR mode stops, and the red light at the presser foot goes off.
> To deactivate the BSR Mode and to quilt without automatic stitch lengths, tap «BSR Mode».
BSR
1
11.7 Securing
Securing in BSR1 Mode with the button «Start/Stop»
Prerequisite:
•
The BSR Presser Foot is fitted and connected to the machine.
•
The BSR display opens and a BSR1 Mode is active.
> Lower the feed dog.
> Lower the presser foot.
> Push the button «Needle position Up/Down» 2x.
– The bobbin thread is brought up.
> Hold the upper and the bobbin thread.
> Push the button «Start/Stop».
– Start the BSR Mode.
> Sew 5 – 6 securing stitches.
> Push the button «Start/Stop».
– The BSR Mode stops.
> Cut the thread.
Securing in BSR2 mode
Prerequisite:
•
The BSR presser foot is attached and connected with the machine.
•
The BSR display is open and the BSR2 mode is activated.
> Lower the presser foot.
> Push the button «Securing».
> Press the foot control or the button «Start/Stop».
By moving the fabric some short securing stitches are sewn, then the programmed stitch length is activated
and the securing function is deactivated automatically.
BERNINA Stitch Regulator (BSR)
(optional accessory)
105