Charging And Starting Specifications - Mercury 200 OptiMax Jet Drive Service Manual

Charging and Starting System

Charging and Starting Specifications

Alternator output (regulated)
Output at the battery at 2000 RPM
Output at the alternator at 2000 RPM
Voltage set point
Regulator current draw
Ignition switch "OFF"
Ignition switch "ON"
Starter draw
Under load
No load
Average engine RPM when cranking
Starter solenoid current at 12.6 volts
Pull in coil
Hold in coil
Start solenoid current draw
Starter brush length (minimum)
Battery rating (minimum)
Marine cranking amperes
Cold cranking amperes
Ampere hour (Ah)
Lubricants, Sealants, Adhesives
Tube Ref No.
Liquid Neoprene
25
2-4-C with Teflon
95
Special Tools
Flywheel Holding Tool
Protector Cap
1. All model alternator specifications require an amperage draw of less than 1.0 mA with the ignition key in the "OFF" position and an amperage draw
of not more than 350.0 mA with key in the "ON" position.
Page 2B-2
Charging and Starting Specifications at 21 °C (70 °F)
1.
Description
Holds and/or turns the flywheel while making engine repairs, also used to torque
the flywheel or the engine coupler
4738
Protects the crankshaft when removing the flywheel; use with flywheel puller
(91‑849154T 1)
13445
Where Used
Starter brush lead connection
Starter ground wire connection
Bushing and belt tensioner arm assembly
Battery terminal bolts
Belt tensioner
Solenoid actuating plunger
91‑ 52344
91‑ 24161
28–36 A
42–48 A
14.5 ± 0.25 volts
0.585 mA
150.0 mA
200 A
65 A
300–325 RPM
40 A
10 A
4 A
6.35 mm (0.25 in.)
1000
800
180
Part No.
92- 25711 3
92-802859A 1
90-8M0050731 MAY 2011