Ignition Specifications; Charging And Starting Specifications - Mercury 200 OptiMax Jet Drive Service Manual

Ignition Specifications

Type
Spark plug
Spark plug gap
Maximum timing
Idle timing
Throttle position sensor
At idle
At WOT

Charging and Starting Specifications

Alternator output (regulated)
Output at the battery at 2000 RPM
Output at the alternator at 2000 RPM
Voltage set point
Regulator current draw
Ignition switch "OFF"
Ignition switch "ON"
Starter draw
Under load
No load
Average engine RPM when cranking
Starter solenoid current at 12.6 volts
Pull in coil
Hold in coil
Start solenoid current draw
Starter brush length (minimum)
Battery rating (minimum)
Marine cranking amperes
Cold cranking amperes
Ampere hour (Ah)
1. All model alternator specifications require an amperage draw of less than 1.0 mA with the ignition key in the "OFF" position and an amperage draw
of not more than 350.0 mA with key in the "ON" position.
90-8M0050731 MAY 2011
Charging and Starting Specifications at 21 °C (70 °F)
1.
Ignition Specifications
1.1 mm (0.043 in.)
Not adjustable; PCM controlled
Not adjustable; PCM controlled
Digital inductive
NGK IZFR6J
0.4–1.3 VDC
4.0–4.7 VDC
28–36 A
42–48 A
14.5 ± 0.25 volts
0.585 mA
150.0 mA
200 A
65 A
300–325 RPM
40 A
10 A
4 A
6.35 mm (0.25 in.)
1000
800
180
Specifications
Page 1A-3