Starter Assembly (Solenoid Driven Bendix) - Mercury 200 OptiMax Jet Drive Service Manual

3. Remove the three screws securing the solenoid to the starter. Remove the solenoid from the starter.
a
Pinion Gear Removal
1. Remove and discard the snap ring securing the pinion gear to the starter shaft.
2. Remove the pinion gear from the starter shaft.
NOTE: The removal of the pinion gear may require the use of a small gear puller.
a

Starter Assembly (Solenoid Driven Bendix)

Pinion Gear Installation
1. Verify the starter shaft splines are clear of debris. Use a razor blade to clear debris from the root area of the starter shaft
splines.
90-8M0050731 MAY 2011
a - Screws
32116
a - Pinion gear
b
b - Snap ring
32115
Charging and Starting System
23494
Page 2B-31