Windscreen Wiper And Washer System - Skoda Octavia II 2004 Workshop Manual

2 Windscreen Wiper and Washer Sys‐
tem
⇒ "2.1 Windscreen wiper and washer system", page 85
⇒ "2.2 Removing and installing rear window wiper", page 89
⇒ "2.3 Removing and installing Sensor for rain and light detection
G397 ", page 92
2.1

Windscreen wiper and washer system

⇒ "2.1.1 General description", page 85
⇒ "2.1.2 Fault recognition and fault display, coding", page 85
⇒ "2.1.3 Removing and installing the wiper arms with wiper blades
and setting their final setting", page 85
⇒ "2.1.4 Removing and installing wiper motor with linkage", page
87
⇒ "2.1.5 Removing and installing wiper motor from linkage", page
87
2.1.1 General description
♦ Description of the system and the function ⇒ Self-study pro‐
gramme No. 54 ; Škoda Octavia II Electrical Components .
♦ The wiper motor control unit - J400- and the windscreen wiper
motor - V- are installed as one component and cannot be re‐
placed separately.
♦ To remove the wiper blades the wiper arms must be moved
into the "service/winter position". Service / winter position is
activated by positioning the windscreen wiper lever within 10
seconds after switching off the ignition in position "flick wipe".
Further information ⇒ Owner's manual Octavia II .
2.1.2 Fault recognition and fault display, cod‐
ing
The vehicle voltage control unit - J519- , which regulates the
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
functions of the windscreen wiper and washer system, is equip‐
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
ped with self-diagnosis which facilitates the fault finding.
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Use the ⇒ Vehicle diagnostic tester for troubleshooting and cod‐
ing.
2.1.3 Removing and installing the wiper arms
with wiper blades and setting their final
setting
Note
If the wiper motor is switched on during work, the front flap must
be closed and the ignition must be switched on, otherwise the
voltage supply of the wiper motor is interrupted.
Special tools and workshop equipment required
♦ Extractor for wiper arms - T10369/1-
Removing
– Switch off the ignition and all electrical consumers!
Octavia II 2004 ➤ , Octavia II 2010 ➤
Electrical system - Edition 12.2013
2. Windscreen Wiper and Washer System
85