Skoda Octavia II 2004 Workshop Manual page 115

Work procedure
The headlight on the left
– Only remove protective foil on the reverse side of the foil in the
area -1-.
– Glue the self-adhesive foil as shown in the figure, place onto
the parting plane -arrow- on the left-hand side of the headlight
glass and press forcefully in the area -1-.
– Carefully pull off the -clearer- mounting part of the foil from the
lens shown in the figure.
– On the lens there is only the protective foil -1-.
The headlight on the right
– Only remove protective foil on the reverse side of the foil in the
area -2-.
– Glue the self-adhesive foil as shown in the figure, place onto
the parting plane -arrow- on the right-hand side of the head‐
light glass and press forcefully in the area -2-.
– Carefully pull off the -clearer- mounting part of the foil from the
lens shown in the figure.
– On the lens there is only the protective foil -2-.
Note
Inform the customer about the corresponding notes for removing
the residual adhesive after pulling off the protective foil, e.g. tex‐
tiles soaked in isopropyl alcohol (do not use any aggressive
solvent, which can damage the polycarbonate lenses).
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Octavia II 2004 ➤ , Octavia II 2010 ➤
Electrical system - Edition 12.2013
1. Headlights – halogen headlights
107