Pentair Hydromatic H-03-000 Installation And Service Manual
  1. Manuals
  2. Brands
  3. Pentair Manuals
  4. Control Panel
  5. Hydromatic H-03-000
  6. Installation and service manual

Pentair Hydromatic H-03-000 Installation And Service Manual

Standard electrical control panel
Hide thumbs
1
2
3
4
5
6
7
8
Table of Contents

Advertisement

Quick Links

Download this manual
STANDARD ELECTRICAL
CONTROL PANEL
INSTALLATION AND SERVICE MANUAL
NOTE! To the installer: Please make sure you provide this manual to the owner of the equip ment or to the responsible
party who maintains the system.
Item # H-03-000 | Part # 5625-000-1 | © 2012 Pentair Pump Group, Inc. | 10/31/12

Advertisement

Table of Contents
loading

Related Manuals for Pentair Hydromatic H-03-000

Summary of Contents for Pentair Hydromatic H-03-000

  • Page 1 NOTE! To the installer: Please make sure you provide this manual to the owner of the equip ment or to the responsible party who maintains the system. Item # H-03-000 | Part # 5625-000-1 | © 2012 Pentair Pump Group, Inc. | 10/31/12...

  • Page 2: General Information

    WARNING: Before handling appropriate ter mi nal blocks in General these pumps and controls, the control panel. If the heat always disconnect the power sensor lead from the pump Information first. Do not smoke or use is wired as indicated, re move sparkable electrical devices or jumpers as defined by the Thank you for purchasing your...

  • Page 3: Pump Maintenance

    4. Energize control panel. (Turn the action must show no lazy Pump on power to panel.) movement. Maintenance 5. Check overload relay and 8. Check junction boxes for verify reset mode (if overload moisture. Moisture is sup plied). cause chattering of relays WARNING: Before handling and contactors.
  • Page 4 1. Pump does not run in 3. If #1 and #2 check out, 2. Check for heat sensor Hand position. shut power off to the trip in pump with a jumper pan el. Remove the OFF between HEAT SEN SOR a.
  • Page 5 85% of full volt age to pull b. Using a volt-ohmmeter, Percent Maximum Current in without chatter. If the with scale Current = Difference from x 100 Unbalance Average Current problem is a re cur ring on RX1, measure the _______________ one, measure voltage with resistance be tween the...
  • Page 6 c. Set meter 5. Motor voltage check: scale to at least 2 times Typical the pump motor full Motor Voltage load current. Component Lead Mode Reading d. Place the H-O-A switch Main Winding Black to Start Line Voltage in the Hand position to White start the pump.
  • Page 7 THIS PAGE INTENTIONALLY LEFT BLANK...

  • Page 8: Standard Limited Warranty

    Pentair Hydromatic will cover only the lower seal and labor thereof for all dual seal pumps. under no circumstance will Pentair Hydromatic be responsible for the cost of field labor, travel expenses, rented equipment, removal/reinstallation costs or freight expenses to and from the factory or an authorized Pentair Hydromatic service facility.

This manual is also suitable for:

5625-000-1

Table of Contents