CALIFORNIA PROPOSITION b. Connect the pump heat sensor General 65 WARNING: and seal failure leads (if available on the pump) to the Information This product and appropriate ter mi nal blocks related accessories contain in the control panel. If the chemicals known to the State of Thank you for purchasing your heat sensor lead from the...
Check List: d1. With the power off, remove Panel Off float and On float 1. Check junction box for wires and replace with Maintenance moisture. two jumpers made from 2. Check wiring of pump black, insulated wire. white, red power wires. WARNING: Before handling d2.Turn power on (with H-O-A 3.
Page 4
9. Test for blown fuse. (by the meter), it will return Panel to a reading of infinity a. Check for continuity with a (open circuit). Maintenance V-O-M set on ohm scale. NOTE: Set the meter on the RX10,000 scale to check Single Phase Pump Only: vol tage to pull in without the run capacitor.
Pentair Hydromatic will cover only the lower seal and labor thereof for all dual seal pumps. under no circumstance will Pentair Hydromatic be responsible for the cost of field labor, travel expenses, rented equipment, removal/reinstallation costs or freight expenses to and from the factory or an authorized Pentair Hydromatic service facility.