1. Manuals
  2. Brands
  3. Pentair Manuals
  4. Control Panel
  5. Hydromatic
  6. Installation and service manual

Pentair Hydromatic Installation And Service Manual

Relay logic control panels
Hide thumbs Also See for Hydromatic:
1
2
3
4
5
6
7
8
Table of Contents

Advertisement

Quick Links

Download this manual
RELAY LOGIC CONTROL PANELS
INSTALLATION AND SERVICE MANUAL
NOTE! To the installer: Please make sure you provide this manual to the owner of the equip ment or to the responsible
party who maintains the system.
Item # H-03-481 | Part # 5625-481-1 | © 2014 Pentair Ltd. | 12/11/14

Advertisement

Table of Contents
loading

Related Manuals for Pentair Hydromatic

Summary of Contents for Pentair Hydromatic

  • Page 1 NOTE! To the installer: Please make sure you provide this manual to the owner of the equip ment or to the responsible party who maintains the system. Item # H-03-481 | Part # 5625-481-1 | © 2014 Pentair Ltd. | 12/11/14...

  • Page 2: General Information

    and local codes for the correct conduit hubs when connecting General wire size and circuit protection to this enclosure. Prior to Information to use. The wire should be sized conducting any installation, large enough to handle the full repair or service with regard to This manual contains important load current of the pump(s) you the control panel, refer to the...

  • Page 3: Start-Up Operation

    in the Off position. Now 9. Check operation of start terminal 2 on the start relay connect power to the terminal relay, if supplied on single- to be sure that the relay has block or the circuit breaker as phase panels. operated.

  • Page 4: Troubleshooting

    applicable to a given installation. 3. If pump runs with Troubleshooting The user should exercise jumper, problem is with judgment in defining specific floats. Remove jumpers 1. Pump does not run in requirements based on this guide. and troubleshoot floats Hand position.
  • Page 5 the problem is a recurring To determine if motor current Typical Resistance one, measure voltage with unbalance is a function of the Winding Motor Leads Reading recorder on a 24 hour basis. motor or the power supply: Main Black to Lowest White d.
  • Page 6 f. After the motor has started (within one second) the current should drop to a value much less than full load current. 5. Motor voltage check: Typical Motor Voltage Component Lead Mode Reading Main Winding Black to White Start Line Voltage Main Winding Black to White Line Voltage...
  • Page 7 THIS PAGE INTENTIONALLY LEFT BLANK...

  • Page 8: Standard Limited Warranty

    Pentair Hydromatic will cover only the lower seal and labor thereof for all dual seal pumps. under no circumstance will Pentair Hydromatic be responsible for the cost of field labor, travel expenses, rented equipment, removal/reinstallation costs or freight expenses to and from the factory or an authorized Pentair Hydromatic service facility.

Table of Contents