Table of Contents
Advertisement
Cable Box Universal Remote Control Feature
Universal Remote Control is...
The Remote Control may be set up to control some
basic DSS or Cable box functions.
The Universal Remote Control Setup
1
Find your DSS box or Cable box
Brand Code Number from one of
the charts on the next page.
2
Setup remote.
Hold down DSS CABLE and press
number keys to enter code.
• If code number is 100 or greater,
e.g., press 1 - 0 - 2 for 102.
3
Confirm code entry.
Press POWER* to turn selected unit
ON or OFF.
• See below for controllable functions in each
mode.
Notes
• Please repeat the Universal Remote Control Setup
after replacing remote control batteries.
• The remote control will not operate all DSS receivers
or Cable Boxes made by the manufacturers listed.
If you get no results, your particular brand cannot be
controlled.
Using the Universal Remote Control
(Available Buttons / Functions)
Once the remote control has been properly set up,
you can select TV-VCR, FM, DVD, DSS or CABLE
mode depending on which functions you wish to
control.
Press
, FM, DVD or DSS CABLE
remote control to select the desired mode. (See below
for buttons available in each mode.)
Set to
, FM, DVD:
All TV functions, as well as functions of TV-VCR
or DVD.
Set to DSS CABLE:
• Basic VCR functions, e.g. PLAY, REC, etc.
• CABLE/DSS function, e.g. POWER, ENTER,
NUMBER keys (except 100 key), CH UP/DOWN.
32
on the
,
FM,
Advertisement
Table of Contents
