Table of Contents
Advertisement
perform "TAPE INTERCHANGEABILITY ADJUSTMENT" in
MECHANICAL ADJUSTMENT procedures.
3. In early units, a washer is used.
When servicing the washer or the P5 Arm Unit, replace only the
P5 Arm Unit with a new one, and remove the washer.
4. Main Cam Gear is supplied as a Main Cam Gear Kit (Ref. No. 8)
only. Main Cam Gear Kit consists of a Main Cam Gear and a Main
Cam Push Nut. However, Main Cam Push Nut is available
separately as a replacement part.
5. The Capstan Motor Ass'y (Ref. No. 46) is supplied as a unit only.
However, the Flat Flexible Cable (Ref. No. 45) is available
separately as a replacement part.
6. The Infrared Remote Control Unit (Ref. No. 123) replacement part
is available as a complete assembly unit only. Do not try to
disassemble the Infrared Remote Control Unit. However, the
battery cover is available separately as a replacement part.
7. Main Cam Push Nut (Ref. No. 414) is not reusable.
If removed, install a new one.
8. When replacing the DVD Frame (Ref. No. 317), be sure to place the
Rating Label (Ref. No. 318) on it.
12.1.3. Electrical Replacement Notes
1. Unless otherwise specified;
All resistors are in
2. Abbreviation
RTL:
Retention Time Limited
This indicates that the retention time is limited for this item. After
the discontinuation of this item in production, it will no longer be
available.
NR:
Non Repairable Board Ass'y
MGF CHIP:
Metal Glaze Film Chip
, K = 1,000
, M = 1,000 k .
87
Advertisement
Table of Contents
