Page 1
ORDER No. 03-SM-016 Service Manual Colour Television TX-29PS2D TX-29PS2F TX-29PS2P TX-29PS2P/B GP3 Chassis SPECIFICATIONS Power Source: 220-240V a.c., 50Hz AV2 IN Video (21 pin) 1V p-p 75Ω Audio (21 pin) 500mV rms 10kΩ Power Consumption: AV2 OUT Video (21 pin) 1V p-p 75Ω...
CONTENTS SAFETY PRECAUTIONS ................................. 2 SERVICE HINTS ..................................3 ADJUSTMENT PROCEDURE AND SELF-CHECK ........................4 WAVEFORM PATTERN TABLE............................... 5 ALIGNMENT SETTINGS ................................6 BLOCK DIAGRAMS.................................. 7 PARTS LOCATION................................. 11 REPLACEMENT PARTS LIST..............................12 SCHEMATIC DIAGRAMS............................... 21 CONDUCTOR VIEWS ................................23 SAFETY PRECAUTION GENERAL GUIDE LINES It is advisable to insert an isolation transformer in the...
SERVICE HINTS How to remove the rear cover 1. Remove the 10 screws as shown in Fig.2. SCREWS SCREWS Fig. 2 LOCATION OF CONTROLS L-Board Focus Screen D-Board G-Board Fig. 3...
(-/v) button on the customer controls at the front the TV set. To exit Self Check, switch off the TV set at the power button. TX-29PS2F TX-29PS2D TX-29PS2P TX-29PS2P/B...
ALIGNMENT SETTINGS (The figures below are nominal and used for representative purposes only.) To access Service Mode select program position 99 and set sharpness to minimum. Press “MUTE” button on remote control and at the same time press the "∨" button on the customer controls at the front of the TV, this will place the TV set into Service Mode1.
JK3201 L OUT P L OUT M R OUT M VIDEO IN R OUT P VIDEO OUT L IN SC2_IN_R SC2_IN_L L OUT SC1_IN_R SC1_IN_L SC1_OUT_L R IN SC1_OUT_R R OUT SC2_OUT_L SC2_OUT_R VIDEO IN VIDEO OUT R IN G IN B IN B IN B OUT...
Page 8
POWER BUS POWER BUS Degauss Mains In coil...
Page 9
SERVICE/TEST SDA_SW1 SCL_SW1 AV LINK SLOW2 SDA_SW2 SCL_SW2 SERVICE XTAL SLOW1 XTAL...
SCHEMATIC DIAGRAMS FOR MODELS TX-29PS2D, TX-29PS2F, TX-29PS2P, TX-29PS2P/B (GP3 CHASSIS) IMPORTANT SAFETY NOTICE Components identified by mark have special characteristics important for safety. When replacing any of these components, use only manufacturers' specified parts. NOTE RESISTOR All resistors are carbon ¼W resistor, unless marked otherwise.