Polaris Outlaw 110 2022 Owner's Manual page 149

4. Press the lamp retainer inward and turn it
counter-clockwise to remove it. Note position
of the lamp positioning tab, then carefully pull
the lamp out.
5. Install the new lamp. Make sure the filament
is horizontal.
6. Reinstall the lamp retainer. Press the retainer
inward and turn it clockwise about 1/4 turn.
7. Start the engine to make sure the lights come
on. If the lights do not operate, see your
POLARIS dealer for service.
8. Reinstall the rubber cover, and reconnect the
lights to the harness.
9. Reinstall the front cover (OUTLAW only).
INDICATOR LIGHTS
1. Remove the handlebar cover or pod to
access the lamps.
2. Remove the indicator wire connections from
the harness.
3. Remove the nut from the back side of the
indicator lamp.
4. Remove the lamp.
5. Apply dielectric grease to the socket and
install the new lamp.
6. Reverse the steps to reinstall all components.
TAIL LIGHT
If the brake light doesn't work, the lamp
need to be replaced.
MAINTENANCE
q
may
147