Polaris Outlaw 110 2022 Owner's Manual page 129

SPARK ARRESTER
Failure to heed the following warnings while
servicing the spark arrester could result in
serious injury or death.
• Do not perform service on the spark arrester
while the system is hot. Allow components to
cool sufficiently before proceeding.
• Wear eye protection and gloves.
• Never operate without the spark arrestor.
• Never run the engine in an enclosed area.
Exhaust contains poisonous carbon
monoxide gas.
WARNING
To remove accumulated carbon, clean the spark
arrester at the intervals recommended in the
Periodic Maintenance Chart section.
1. Remove the six bolts and remove the arrester
from the end of the muffler.
2. Use a non-synthetic brush to clean the
arrester screen. A synthetic brush may melt if
components are warm. If necessary, blow
debris from the screen with compressed air.
3. Inspect the screen for wear and damage.
Replace the arrester if damage is found.
4. Reinstall the arrester.
5. Torque the bolts to 7 ft. lbs. (9.5 Nm).
MAINTENANCE
127