Polaris Outlaw 110 2022 Owner's Manual page 121

OIL CHANGE
1. Position the vehicle on a level surface. Set
the parking brake.
2. Clean the area around the pre-filter plug.
3. Start the engine. Allow it to idle for two to
three minutes.
4. Stop the engine.
Hot oil can cause burns to skin. Do not allow
hot oil to contact skin.
5. Place a drain pan under the engine
crankcase.
6. Remove the pre-filter plug. Allow the oil to
drain completely.
WARNING
7. Wash the oil pre-filter screen with solvent to
remove debris. Allow the screen to air dry.
8. Clean the pre-filter plug. Install a new sealing
washer on the plug. The sealing surfaces on
the plug and crankcase should be clean and
free of burrs, nicks or scratches.
9. Reassemble the pre-filter screen and spring
to the pre-filter plug.
10. Reinstall the pre-filter drain plug. Torque to 11
ft. lbs. (15 Nm).
11. Remove the dipstick. Add 29 oz. (850 ml) of
the recommended oil. Do not overfill. See the
Specifications chapter for capacities.
12. Reinstall the dipstick.
13. Start the engine. Allow it to idle for one to two
minutes.
MAINTENANCE
119