Table of Contents
Advertisement
PB 24 CleanFace - Log Installation
Installation Warnings
NOTE: Consult the installation manual for order of installation. If using propane (LP), convert the
appliance before installing the log set. If using firebacks, install them prior to installing the log
set.
The logs are fragile, especially after being exposed to heat.
Make sure the gas control valve is OFF and the heater is cool prior to conducting service.
Failure to position the parts in accordance with these diagrams or failure to use only parts
specifically approved with this appliance may result in property damage or personal injury.
The burner must be correctly positioned before installing the log set. Make sure the burner is fully
seated and the pilot is properly aligned. See owner's manual for details on burner removal.
Log Set Overview – Oak 94500620
When installed, the ten (10) logs should appear as shown below.
Log #6
Log #5
Log #2
Log #4
© Travis Industries
Maintenance
Log #9
Log #7
5/3/21 - 1529
Log #1
PB 24 CF GSR2 Operation (AUST)
19
Log #10
Log #3
Log #8
Advertisement
Table of Contents
