Travis Industries 430 Mod-Fyre GSR2 Manual page 55

Optional Equipment (for qualified installers only)
Crushed Glass Installation (Optional)
Measuring Glass Quantity
Travis Industries offers glass in 10-lb. boxes. The 430 Mod-Fyre uses 6 lbs. of glass so it is important
to measure out the appropriate amount of glass for installation. Use a liquid measuring cup to
accurately determine the amount of glass used.

Do not allow the crushed glass to block the air slots or to become too thick (maximum 1 layer
deep on the burner). Failure to properly install glass may lead to sooting and improper burning.

Make sure the gas control valve is OFF and the heater is cool prior to conducting service.

If using propane (LP), convert the appliance before installing the media

This appliance requires the use of a fireback kit. Install the Fireback BEFORE installing the
media.
1. Use a 1/4" nut driver to remove (2) screws
that secure the pilot cover to the media tray
and remove the pilot cover. Gently pull the
silicone sleeve from the spark electrode on
the pilot assembly and re-install the pilot
cover (make sure not to overtighten the
screws).
© Travis Industries
1 Level Cup (8 fl. oz.) (240ml) = 0.95 lbs.
So...1 Slightly Rounded Cup = 1 lb.
WARNINGS
5/20/2021 - 1558
55
430 MF GSR2