Table of Contents
Advertisement
Loosen the two screws nearest the bulb to disengage the bulb
from the holder. Remove the bulb from the holder. Replace
the bulb, making sure not to touch the bulb with your fingers
(grasp the bulb with the bulb packaging or a paper towel).
Tighten the screws until the bulb is secure (do not over-
tighten; this may damage the electrical contacts on the bulb).
Under Light Bulb Replacement
The Under lights in your insert provide additional lighting. The bulbs will burn out over time. Replace the
halogen bulbs with the following bulbs:
To replace, follow the directions below:
1. Shut off gas to the Insert and let it cool for 15 minutes.
2. Remove the glass assembly (see page 22).
3. Remove glass media from the media tray.
4. Use a 1/4" nut driver to remove the (8)
media tray attachment screws that secure
the tray to the burners (set the screws
aside for reinstallation).
5. Lift the media tray up and out of the
firebox.
© Travis Industries
Maintenance
35 Watt 120 Volt T4 Halogen Bulb (GY6.35 Base)
5/20/2021 - 1558
39
430 MF GSR2
Advertisement
Table of Contents
