Daisy-Chaining Crd4001-4000Er Cradles - Motorola WT41N0 Integrator Manual

Connect the DC cable to the power input on the back of the cradle.
4.
Plug the AC line cord into the power supply.
5.
Plug the AC line cord into an AC outlet.
6.
Ethernet Switch, Router or
Hub Connection
CRD4001-4000ER Four Slot Ethernet Cradle Setup
Figure 2-8

Daisy-chaining CRD4001-4000ER Cradles

To connect several cradles to an Ethernet network, up to four Ethernet cradles may be daisychained.
Daisy-chaining should not be attempted when the main Ethernet connection to the first cradle is 10 Mbps as
throughput issues will certainly result. The LEDs on the Primary Ethernet port function in the same way as the
LEDs on the front of the cradle.
To daisychain cradles:
Lift or remove the label covering the Secondary Port on the back of the first cradle.
1.
Connect one end of the daisychain Ethernet cable (either straight or twisted cable can be used) to the
2.
Secondary Port of the first cradle.
Connect the other end of the Ethernet cable to the Primary Port of the second cradle.
3.
Connect additional cradles as described in steps 1 and 2.
4.
Left LED Primary Port
Ethernet Cable
Right LED
Power Port
DC Power Cable
Accessories 2 - 9
AC Line Cord
Power Supply