Mitsubishi Electric PURY-M200YNW-A1 Service Handbook page 387

[8-13 Parts Replacement Instructions (Outdoor Unit) ]
(12) Remove the front pillar by unscrewing the 7 screws. (See Figure 14.)
(13) Disconnect the TH7 sensor holder from the front pillar. (See Figure 14 Rear.)
(14) To remove the front heat exchanger, first remove the front, left, right, and center frames by unscrewing the 16 screws.
(See Figure 15.)
To remove the right and left rear heat exchangers, remove the top and the rear frames in addition to the front, left, right,
and center frames by unscrewing the 21 screws. (See Figure 15.)
(15) Remove the center front pillar by unscrewing the 4 screws. (See Figure 16.)
Rear frame
Left frame
120
- chapter 8
Front pillar
Front heat exchanger
Figure 14
Top frame
Center frame
Front frame
Figure 15
Connector
Front pillar
TH7
Rear
Right frame
Center front pillar
Figure 16
BS_08_L